User manual

8 FastSCAN
4. The status indicator at the bottom right of the screen (labeled 1 in Figure 3)
should change from Scanner disabled to Scanner initializing... After approx-
imately 10 seconds this should change to Scanner on-line, indicating that the
system has initialized.
Note: Do not depress the trigger while the Wand is initializing.
5. When setting up the system for the first time or changing Wands open the Scan-
ner Properties box (Figure 4) via Scanner/Properties... .
6. Confirm that the Calibration file corresponds with the Wand you are using
(if not you may need to select the appropriate configuration file) and that the
Hardware version is set correctly. For current systems the correct setting is 3. If
the scanner has not come online ensure that Driver enabled is checked. If the
Wand has not been used with the system before, you may also have to install
the configuration file.
Figure 5: The Wand Hemisphere Setup dialog box.
7. When the system has initialized, and the status bar indicates that the scanner is
on-line, pull the trigger on the Wand. The Wand Hemisphere Setup dialog box
(Figure 5) will prompt you to define the hemisphere of operation—follow the
instructions in the dialog box.
8. Once the hemisphere has been defined FastSCAN is ready for use.