Instruction Manual

2022-11-09 Aranet NH3 sensor kit
FOR MORE DETAILED INFORMATION ABOUT ARANET PRODUCTS, PLEASE VISIT ARANET.COM, CONTACT YOUR ARANET REPRESENTATIVE OR WRITE TO
[e-mail]. PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
© 2022 SAF TEHNIKA, JSC. ALL RIGHTS RESERVED.
Visual 2. Connecting the Aranet transmitter with the NH
3
sens or
Aranet 0-10 V transmitter with 24 VDC power supply
DOL 53 NH
3
sensor
Slot no. in the
junction box
Corresponding
wire color
Wire color
1
+VCC
White
+24 V
White
2, 3
GND, INPUT -
Green/yellow
GND
Green/yellow
4
INPUT+
Brown
0 – 10 V output
Brown
Third step: connect the kit to the mains power cable
▪ Make sure the cable is not connected to the power mains. Unscrew and take off the transmitter’s lid.
▪ Connect the cable to the transmitter as shown in the scheme below.
▪ To ensure high IP protection, the cable must be directly connected to mains power.
▪ After finishing the assembly, tighten the cable glands to ensure water protection.
▪ Screw back the transmitter’s lid.
Connection to mains power
Wires
N – Neutral
Blue
L – Live
Brown
GND*
Green/yellow
*The wire should be clipped at the end.
Visual 3. Connect ing the sens or k it with the m ains power