User guide

AIRWASH SYSTEM / SECONDARY
AIR
The airwash has an internal sliding plate with
slots, housed in a cover plate, and is located
above the fire door. Sliding the control knob to
the RIGHT as far as it will go, achieves the fully
open position.
Sliding it to the LEFT will shut off the air inlet
slots.
Additional Air Inlet
Your stove has additional air inlets found at the
bottom of the main fire doors. These should be
used for a short period whilst lighting the stove or
after re-fuelling.
BURNING WOOD
 Set the fire by using scrunched up newspaper
and place a layer of dry kindling wood on top
of this.
 The use of two or three fire lighters may assist
in lighting the kindling.
 Set the secondary and additional air inlets
to the fully open position.
 Light the fire.
 After the kindling has caught light, you
should leave the fire door ajar by about
20mm. This will aid flue draw.
 The flue draw should be established after
five minutes, and the kindling reduced to
form an ember bed.
 Carefully load the stove with well seasoned
wood and close the fire door.
 After ten to fifteen minutes, close the addi-
tional air inlets and regulate the
airwash control, typically reduce to
approximately half way.
BURNING SOLID FUELS
 Set the airwash to one quarter open and
the additional air inlets fully open.
 Light as with wood, with kindling and fire
lighters.
 Once flue draw has been established,
after about five minutes, carefully load the
stove with fuel and close the door.
 After another five minutes close the addi-
tional air inlets.
 Regulate the burning rate by the
thermostat control.
 The airwash should be opened sufficiently
to keep the door glass clean.
USER GUIDE
5
Wet Stove User Guide