User's Manual
ArradaSystems,Inc.
4633OldIronsidesDrive,Suite415,SantaClara,CA95054,USA
• Connect the equipment to outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment. This
device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including
interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
6.
Radio Frequency Radiation.
To comply with FCC RF exposure compliance requirements, a separation distance of
at least 25 cm must be maintained between the antenna of this device and all persons.
This device must not be co-located or operating in conjunction with any other
antenna or transmitter.
OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module in the user manual of the end product. The
user manual which is provided by OEM integrators for end users must include the
following information in a prominent location. “To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter must be installed to
provide a separation distance of at least 25 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter
7. Label for end product must include
“ Contains FCC ID: XZB-MAXR900” or
“ A RF transmitter inside, FCC ID: XZB-MAXR900”.