Quick Start Guide

ManualsBrandsAR ManualsAudio EquipmentBluetooth Speaker

AWSF6RBK QSG 00

Instructions en français ......................................................... 7

Instrucciones en español ..................................................... 13

rechargeable wireless speaker

with LED ﬂickering ﬂame light

Quick Start

Guide

Summary of content (6 pages)

PAGE 1
rechargeable wireless speaker with LED flickering flame light Quick Start Guide Instructions en français.......................................................... 7 Instrucciones en español......................................................
PAGE 2
1 Unpack Make sure the following items came in this package: • (1) Rechargeable Wireless Speaker • (1) Power adapter Power adapter Speaker 2 Charge the speaker Before you start using the speaker for the first time, it’s a good idea to charge it completely. To charge the speaker: Open the rubber door covering the jacks on the back the speaker. Plug the included power adapter into the DC IN jack behind this door. Plug the other end of the power adapter into a power outlet.
PAGE 3
4 Pair and connect to your phone Enable Bluetooth on your smartphone or other device (if it isn’t already on). Make sure the Power/Pair indicator on the speaker is blinking rapidly. (If it isn’t, give a quick double press to the button. The speaker gives an audio signal.) Power/Pair Volume DC In Note: If you’ve previously paired a different Bluetooth device with this speaker, the speaker will automatically attempt to reconnect to that device when you switch the speaker on.
PAGE 4
Adding Speakers (Stereo Mode) If you have a second AR Sedona wireless speaker, you can use it together with this one in stereo mode. To use 2 AR Sedona speakers together Power/Pair in stereo mode: Add Speaker Volume 1. Turn on both speakers. (Press and hold the Power/Pair button on the back of each.) 2. Press and hold the Add Speaker button on the back of the first DC In speaker until the Power/Pair light starts flashing white. 3.
PAGE 5
Using the AUX input Use a mini-jack audio cable (not included) to connect the audio output from your device to the Aux In audio input on the speaker’s back panel (open the rubber door to access the jack). The speaker automatically switches to the Aux In audio. (For two-speaker setups, plug into the one whose Power/Pair light is blinking every 5 seconds.) To listen to Bluetooth audio again, unplug the cable from the speaker’s Aux In jack.
PAGE 6
If you have any questions about this product, visit Acoustic-Research.