Installation Guide
2
5
8
7
6
6A
9
4
3
1
10
Pump
Hose
1
Pump
High Pressure Hose
Reset
Package content:
1. Pressure Water Unit
2. Manual
3. Adjustable Spray Nozzle
4. Spray Lance
5. Lance Extension
6. Gun
7. Detergent Tank
8. Nozzle Cleaning Tool
9. High Pressure Hose
10. Garden Hose Fitting
Trigger Lock (6A)
1 2
3
2. Insert lance adapter into the
gun push and turn clockwise to
positive stop as shown.
3. Press release button on
bottom of gun toward back of
the gun, then insert high pressure
hose.
4
4. Accessories
attachment view.
5
5. Attach the high
pressure hose onto the
pump water outlet by
turning clockwise and
hand tightening.
6
7
8
6. a) Attach swivel adapter to
pump water inlet, if not already
attached. Notice the swivel
adapter is marked with the words
pump and hose. Make sure to
connect pump side of the adapter
to the pump water inlet to prevent
damage to the threads.
b) Attach garden hose to swivel
adapter side marked hose.
2
1
Safety Button
Trigger
7. Activate the lock by
holding the gun and push
the lock from right to left.
Squeeze trigger to make
sure the trigger does not
move. The saftey trigger
lock should be locked at
all times when pressure
washer is not in use.
9
8. a) Plug the power cord
into a grounded 120V outlet
and press the reset button as
shown.
b) THIS MUST BE DONE
EACH TIME THE UNIT IS
PLUGGED IN AN OUTLET.
Assembly And OperAtiOns sheet
Assembly
OperAtiOns
Ar118
On
Off
9. a) Pull trigger then turn on power switch.
b) After turning off power, pull trigger to relieve line pressure
before removing spray gun and hose.


