Installation Guide

STEP 6
Install the float valve back to its original placement as noted before
STEP 14
STEP 7
Install the to cover of cooler back in its original position
STEP 15
STEP 8STEP 1
Attach the new filter to filter head by pushing in, and turning to the
right until it stops
STEP 6
STEP 2
Place the bottom of the cabinet cover over the plastic L-shaped clips at
the bottom of the cooler and press down gently
STEP 7
STEP 3
Push the top of the cabinet cover into place and let slide up naturally
and click into position
STEP 8
Replacing Your Water Filter
Remove the baffle from the cooler and clean with a clean dish towel, and
water (do not use bleach or any cleaners, you may use a small amount of
soap if desired)
Clean the cold tank with a clean dish towel, and water (do not use bleach
or any cleaners, you may use a small amount of soap if desired)
Remove the drip tray by pulling towards you
Remove the screw located at the bottom of the cabinet on the front of
the cooler
Push the cabinet cover down and pull towards you
Remove the drain plug from the rear of the cooler (water will drain out of
the cooler immediately, so you will need a bucket or receptacle to catch
the water