Installation Guide

Locate Water Source
STEP 1
Locate the cold water source
STEP 1
To confirm you are using the cold water please shut off the water source
valve and turn on your cold water faucet. No water should come out.
STEP 2
Confirm Your Water Source Is Off
STEP 1
Drain the water from the faucet by turning on the hot and cold faucets
until no water is running
STEP 2
WARNING: YOU MUST OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES
Make sure that the water source you will work with is connected to the
cold faucet on you sink by a water line hose. The cold faucet can be
determining which faucet is the cold faucet and connecting to that water
line hose
Turn the valve clockwise to shut of the water
A water source looks like this. It can be typically found underneath the
closest sink to were you would like to place your cooler