Installation Guide

First Steps
Determine where your cooler is going to be located and place it close to the determined area This drinking water system must be maintained in accordance with the manufacture's instructions
DO NOT PLUG IN (see instructions that are provided with filter)
A professional licensed plumber can perform the install or you can obtain the following items at your local hardware store: Maximum PSI = 10-125 psi/Capacity = 1500 gallons/Temperature = 35-100 F
Attaching Filter Re-attaching Front Cabinet
STEP 1
Place the bottom of the cabinet cover over the plastic L-shaped clips at
the bottom of the cooler and press down gently
STEP 1
STEP 2
Push the top of the cabinet cover into place and let slide up naturally
and click into position
STEP 2
STEP 3
Insert the previously removed screw into the bottom of the cabinet
cover
STEP 3
STEP 4
Re-attach the drip tray by pushing in
STEP 4
Cooler Set Up
Filter Specifications
Remove the drip tray by pulling towards you
Remove the screw located behind the drip tray
Push the cabinet cover down and pull towards you
Attach filter to filter head by pushing in, and turning to the right until it
stops