Installation Guide

Care & Maintenance
BRUSHED STAINLESS
Gently clean with warm water and a mild liquid detergent to
remove any dirt or debris.
Stainless steel is highly-resistant to corrosion, the surface can
be susceptible to cosmetic spots by saltwater and airborne
chemicals. Simple cleaning should restore the stainless steel
to its original appearance. Use a Scotchbrite pad in the
same direction of the existing brushed surface.
DO NOT use steel wool to clean stainless steel, as the
carbon steel will contaminate the stainless steel, causing rust.
COATED STAINLESS & POLYMER
This coated finish is extremely durable and resistant to
scratches, but can still chip if the cover is hit or knocked
against with sharp objects.Gently clean with warm water
and a mild liquid detergent to remove any dirt or debris.
DO NOT use bleach, caustic, acid-based cleaning materials
or detergents, or abrasive materials (such as Scotchbrite) or
other hard objects against the coated finish.
V2+ cover shown for demonstration. V2+ cover shown for demonstration. V2+ cover shown for demonstration. V2+ cover shown for demonstration.
MC-V1 -TI -WHT
Debris Cover V1+
Installation
2) Slide the existing cover up
to remove. New cover must be
installed BEHIND the hydrant
faceplate.
Note the 5° wedge will angle
the hydrant downward for
drainage.
1) Remove existing cover by
releasing hydrant mounting
screws. There is no need to
shut off the water supply. Do
not disconnect from plumbing.
3) Replace mounting screws to
secure assembly to wall.
4) Check cover alignment and
operation. Adjust friction hinge
if needed.
Still have questions?
We’re here to help Monday to Friday 9AM-4PM PST. Email us at
[e-mail] or give us a call at [phone].