Installation Instructions

Operating your Robotic Cleaner
Cleaning Cycle
1. During the cleaning cycle, the remaining time will be shown
on the main screen of the APP in format of HOURS:MINUTES
2. During the cleaning cycle, the robotic cleaner:
- Moves across the pool floor picking up dirt and debris.
- Changes direction and rotates automatically according to the
selected program
- Climbs the pool walls every few minutes, as set in its internal
program.
Note: The robotic cleaner might occasionally stop moving
for a few seconds. This is part of normal operation, not a
malfunction.
Stopping Robotic Cleaner Operation
1. The robotic cleaner moves automatically to STANDBY after every cleaning cycle and the operation LED starts flashing.
2. To stop the cleaner operation during a cleaning cycle, either press the operation button once, or tap the OFF button
on the APP.
The operation LED starts flashing and the cleaner is in standby mode.
Pulling Cleaner Unit out of the Water
1. Verify that the operation LED is in Stand-By mode (flashing).
2. Unplug the floating cable from the power and control unit.
3. Pull the floating cable to bring the cleaner unit closer, until it is possible to take hold of thehandle.
4. Using the handle, lift the cleaner unit out of the pool.
CAUTION: Do not use the floating cable to lift the cleaner unit out of the water.
Starting the Robotic Cleaner :
1. Open the "AQUABOT RC" Application.
2. In case the Bluetooth option is turned OFF on your phone, the APP will automatically direct you to activate it.
3. The APP will present the discovered robots in its range (RoboCleaner xxxxxx).
4. Tap on robot's name. The APP will connect to your power and control unit. The Connected icon on the power and control unit
will light to indicate correct match.
5. To activate the cleaner, tap the ON-OFF icon on the APP, or press on the START button on the power and control unit.
6. The Operations LED will turn ON and the robotic cleaner will start the cleaning program.
ON-OFF icon START button
Check filter
Illuminated light means the filter bag must be removed, cleaned and
properly installed back into the robot to work efficiently.
00:01:25