Installation Instructions

Activating your Robotic Cleaner
The power and control unit is connected to the robotic cleaner via the floating cable. The unit is powered by AC power (1) and supplies
low voltage and commands to the cleaner unit through the outlet socket (2).
The power and control Unit features a control panel (3) with 2 indicators :
a. Connected Indicator - light in blue color when connected to a mobile device.
b. Full-Bag Indicator - light in blue color when the filter bag is full and requires cleaning.
1. Download and install the Application from Google Play (Use the below QR code for direct access).
2. Place the power and control unit at least 3.6 meters/11.8 feet from the pool and at least 12 cm/4 inches above the surface.
CAUTION: The power and control unit must not be exposed to water or to direct sunlight.
3. Connect the power and control unit to wall socket. The Operation LED will blink to indicate that the power and control unit is ready.
4. Spread the floating cable across the pool. Make sure that only the required length of cable is spread across the pool.
5. Before placing the cleaner unit in the water
a. Make sure there are no people in the pool.
b. Make sure that the filters are clean.
c. Make sure the pool conditions are met
6. Place the cleaner in the pool. Hold it for few seconds under water to release trapped air
7. Connect the Floating cable Plug (4) to the power supply unit (socket 2).
Aquacontrol
Connected
Connecté
Conectado
Verbunden
Collegato
Conectado
Check filter
Vérifiez le filtre
Revise el filtro
Filter uberprufen
Controllare il filtro
Verifique o filtro
a
b
1
2
3
4
Android
(> 4.4)
iOS
(> 9)