Instructions / Assembly

— 5 —
Aquatic • 8101 E. Kaiser Blvd. • Anaheim, CA 92808 • [phone] • FAX [phone] • www.aquaticbath.com
Installation Instructions
4-Piece A
2
Composite Shower System Models
Fax on Demand # 1360
Tap down until level. Level lengthwise and widthwise using 3 ft. (915mm)
level by shimming or depressing foundation materials. The unit must be set
level.
Install drain assembly per manufacturer’s instructions. If desired, spread foundation material. When using foundation materials, the following applies: Mix
foundation material. Place three or four mounds of plaster on the subfloor around but away from drain hole. The mounds should be placed high enough so
that when the unit is set, it will cause the plaster to displace and spread. (For Tub/Shower, refer to diagram 12A. For Shower, refer to diagram 12B.)
Place base into framing pocket.
Pre-drill horizontal flanges along top of base section and fasten into each
corresponding stud. Pre-drill both (vertical) side flanges and fasten to side
studs 8” (200mm) on center. Place cardboard to protect finish.
12A 12B
13 14
15
Lift and place back wall, making sure locking tab is engaged.
16
INSTALLATION PROCEDURE, CONT.