Instructions / Assembly

— 3 —

Customer Service: 800-945-2726

Remove base.

Measure the distance between the top of the back horizontal flange and the bottom of

the pan ledge, approximately 1-1/2”. Mark this dimension on the back studs (or wall),

below the first mark.

Installation Data

6030SPANL/R, 6030SPANML/R,

6030STUBL/R, 6030STUBML/R

Fasten a 1” x 3” ledger strip along the rear and sides of framing

(immediately below marks).

Install drain assembly per manufacturer’s instructions.

Place base into framing pocket.

Tap down until level. Level lengthwise and widthwise using 3 ft. (915mm) level by

shimming, if necessary. The unit must be set level. Front apron should be firmly

on the floor.

Assure waste pipe protrudes well into drain fitting. (pan install only)

Installation Instructions