Specifications

4
7.3 Remove Plastic Electrical Tee Fitting
7.4 Cleaning Quartz Tube
7.5 Re-installing Quartz Tube Assembly
8.0 UV Bulb Removal/Replacement
8.1 Electrical Connector Assembly Removal
8.2 Removing The UV Bulb
8.3 Removing the Bulb Cushion and O-Rings
8.4 Install Acorn Nut
8.5 Check For Leaks
9.0 UV Bulb Installation
9.1 Seating Bulb End Cushion
9.2 Installing O-Rings On Bulb End
9.3 Connecting Bulb Pins To Bulb Connector
9.4 Inserting Bulb Into Quartz Tube
9.5 Making Electrical Connection To Bulb
9.6 Reinstall The Electrical Enclosure Bonnet
9.7 Plug UV Unit Into Electrical Power
9.8 Providing Power To EA Unit
10.0 Maintenance – Scheduled Bulb Replacement
10.1 Annual Reminder
10.2 Disconnect The Power Cord
10.3 Remove Electrical Enclosure Bonnet
10.4 Remove The Bulb
11.0 Additional UV Unit Maintenance
12.0 Normal Operating Results
12.1 Ponds
12.2 Swimming Pools, Fountains, Water Features, Waterfalls
13.0 Winterizing
13.1 Freeze Damage
13.2 Freezing Weather Precautions
14.0 Swimming Pool Chemicals
15.0 How To Obtain Service
16.0 Parts Schematic and Part Numbers
17.0 Frequently Asked Questions
17.1 Salt Water Use
17.2 Filter Cleaning
17.3 Time Clock Operation
17.4 Residual Effect From UV
17.5 Horizontal Mounting Of UV Unit
17.6 Below Water Installation
17.7 Multiple UV Units For Larger Installations
17.8 GFCI (Ground Fault Circuit Interrupter) Necessity
18.0 Troubleshooting
18.1 UV Bulb Will Not Light At Startup
18.2 UV Bulb Was Lit, But Is Not Lit Now
18.3 UV Bulb Stays Lit When Pump Is Off
18.4 Water Is Green
18.5 GFCI Trips
18.6 Unit Makes Noise When Operating
18.7 Water Leaks From Electrical Enclosure Bonnet
19.0 Specications