Technical data

Electronic scale eliminator ANTICA
++
2
Application of AntiCa
++
devices
AntiCa
++
devices are intended to protect:
• Boilers and heat generators
• Home appliances and domestic hot water heaters, including gas-fired instant hot water
systems, eliminating expensive maintenance of heating elements
• Heat exchangers, converters, water distribution systems, heating district distribution
systems, generation of hot water, hydronic systems
• Process equipment and systems in which the formation of scale takes place as a result of
temperature or pressure changes in hard water.
AntiCa
++
Performances
The high performance of AntiCa++ devices in hard water applications is because they are
designed, manufactured and installed in consideration of the following parameters:
• chemical composition of the treated water
• the pipe diameter where the device is being installed
• volume of water or water velocity flow through the pipe where the device is being installed
• pipe material where the device is being installed – metal or plastic
Description of AntiCa
++
devices
AntiCa
++
devices consist of:
• electronic unit
• power coil cable (red)
• circuit for control level based on flow signal from flow meter ( EUV xx AI )
• circuit for level switching through timer ( EUV xx T a TI )
• circuits for manual switching based on flow ( EUV xx MI )
• circuits signals of device functions
Signalling
a) optic signals:
• power ON – red LED diode marked "POWER"
• power to coil cable (red) - green LED diode marked "DESCALING"
• control based on water volume flow EUV xx AI
• scale change control EUV xx T, a TI
Note.:
Types EUV 15 Dom to EUV 25 Dom have only visual green LED diode signal marked
“DESCALING”
b) acoustic signal – type EUV xx MI, TI a AI
• power disconnection – audio ringing
c) contact signal – EUV xx MI, TI a AI
dry open contact on terminal strip for remote signalling or lock out in the event of lost signal of
the output circuit
AntiCa++ location and installation
Install AntiCa++ device upstream of the process device that needs to be protected against
scale formation.
Install the device downstream of open-to-atmosphere water reservoir or tank. The installation
upstream of the water reservoir or tank open to atmosphere is not recommended. The
treated water open to atmosphere even for a short period of time loses the benefit of