Technical data

Electronic scale eliminator ANTICA
++
13
Technical data for digital Volume measurement devices EUV xx AI.
(OPTO OD 01, OD 02.)
Sensor IR – reflection ray in accordance with DIN
19234
Feeder voltage
8,2 V DC ( z EUV xx
AI )
Reflection currant < 1 ,2 mA
Specification
Current without
reflection > 2,1 mA
DN 40 - 125 1 impulse / litre Constant
DN 150 - 300 1 impulse / 10 litres
Connecting digital volume counting sensor:
1. Connect middle wire (opto+) shield cable to terminal #4.
2. Shielding (opto-) connect to terminal #1.
When connecting EUV xx AI to non- metal pipe jump terminals #2 and #3.
When connecting EUV xx AI to metal pipe do not jumper terminals #2 and 3 (leave them
free).
Technical data of current sensors.
When ordering current sensor 0-20 mA or 4-20 mA, specify the characteristic of receiver
(graph or table). If the characteristic of the receiver is linear, it is adequate to specify
the starting and finishing point ( eg. 0 mA=0 m
3
. 20 mA=15 m
3
).
Installation of current sensor:
1. Middle wire („ + I „) of shading cable connect to terminal #.4
2. Shading ( „– I „) connect to terminal #1.
When connecting EUV xx AI to non-metal pipe jump terminal#2 and #3.
When connecting EUV xx AI to metal pipe do not jumper terminals #2 and #3 (leave
them free)