Use and Care Manual

19
AQUASURE PREMIER SERIES
II. Replacing Stage 1 & 2 Pre-Filters
1. Turn OFF tank’s ball-valve. (See Diagram L-1)
Dia. L-2
Dia. L-4
4. Twist the Pre-Stage Filters quarter turn to
the right to unseat the lters from the system.
(See Diagram L-4)
Dia. L-1
Dia. L-5
Instruction continues on the next page
2. Turn OFF cold water supply from feed water
adapter to the system. (See Diagram L-2)
3. Turn on drinking water faucet lever briey
to release the water and relief the built-up
pressure inside the system. This will make
removing of lters easier. (See Diagram L-3)
5. Replace the system with new Pre-Stage
Filters by setting them on to the system and
twisting them quarter turn to the left. (See
Diagram L-5)
6. Repeat the same process for stage 2.
7. Turn ON cold water supply and Tank Ball
Valve.
8. Check for leaks.
9. Secure the FLOWLOK tray by screwing the
locking screw behind the lters.
Dia. L-3