Use and Care Manual

8
www.AQUASUREUSA.com
Tel: [phone]
4. Pre-install environment checklist
(Continued)
• A 120 volt electric outlet must be within 6 feet of the softener. The transformer has an
included 8 foot power cable. Be sure the electric outlet and transformer are protected
from water and wet weather.
• If installing outside, necessary steps must be taken to ensure the softener, installation
plumbing, wiring, etc. are protected from the elements and contamination sources.
• Handle with care when moving the water softening system. Do not drop, drag, or set on
areas with sharp protrusions.
• The system works on standard 120v power plug only. Do not use any other transformer
except the one that is included with the system.
• Transformer must be plugged into an indoor 120 volt, grounded outlet.
• Use only clean water softening salt with at least 99.5% purity. Extra course grade or
crystal salt is recommended. Do not use rock, block or granulated salts. These contain
contaminants that could cause problems during maintenance.
• Always keep easy-ll lid in closed position unless servicing or relling the unit.
• Comply with all state and local, building, plumbing, and electrical codes.