Use and Care Manual

6
www.AQUASUREUSA.com
Tel: [phone]
I. System Review and Installation Tools
Please take the system and all the components out of the box. Inspect the system and all the
connection ttings carefully and make sure nothing was damaged during shipping. If any part is
cracked, broken, or missing, please do not proceed with the installation. Contact Aquasure support or
your distributor for a diagnosis or exchange.
INSPECTION & PREPARATION
System Components
1. Digital Control Valve
2. Upper Distribution Basket
3. Softener Housing
4. Riser Tube & Bottom
Distribution Basket
5. Thin Prole Hydraulic Meter
6. High Strength Bypass Valve
7. 1” Yoke Connection
(3/4” Available on request)
8. Resin Tank (Pre-lled)
9. Brine Well
10. Float Valve
11. Grid Plate
12. 24” of 3/8” Brine Line
13. 10’ of 1/2” Drain Line
14. Power Adapter
Required Tool List for System Installation
• Channel Locks
• Screwdriver
• Plumber’s Tape
• Utility Knife
• Two Adjustable Wrenches
• Use 1”
(Or 3/4” Depending on system) copper, brass,
or PEX pipe and ttings. Some codes may
also allow PVC plastic pipe.
• Silicone Grease (Lubricant)
• Please note modication to home plumbing
may require the use of additional tools.
Required Components not Included with the System
• 80 lbs Extra Course Grade Salt Pellets are needed to ll the brine tank. The softener
system will use any kind of salt formulated for water softener use, but it is advised to use the
pellet-shaped salt as it tends to dissolve more evenly.
(Potassium can be used for a salt-free alternative)
Preassembled Preassembled
Preassembled
1
2
4
5 6 7
8
9
10
11
12
13
3
14