Use and Care Manual
13
AQUASURE HARMONY SERIES
2. Push the brine line into the brine
line connector and make sure it goes
through the o-ring. Secure by pushing
in the locking clip. Pull the brine line to
see if it is secure.
1. Connect the brine line to the control
valve by removing the blue locking clip
on the brine line connector.
IMPORTANT! Make sure the brine line is secure to the elbow quick connection inside the brine
well. If the connection is not secure and sealed, it may not be able to perform a proper system
regeneration when needed, and can potentially cause overll and result in leaks.
STEP 4. Connecting the Brine Tank
3. Open the easy-ll lid on the front of the softener
housing and remove the white cap on the top of
the brine well.
4. Insert the brine line through the upper hole on
the right side of the softener housing and then
through the adjacent hole on the brine well.
5. Push the brine line into the quick connect tting
inside the brine well and give it a tug to make sure
it is thoroughly seated in the quick connection.
6. Replace the white cap and pour in 80 lbs (two
bags) of course grade salt and 5 gallons of tap
water into the brine tank.
7. LIFT TO CLOSE the easy-ll lid.
3
4
5