Use and Care Manual

AQUASURE HARMONY SERIES

STEP 2. Mounting the Control Valve

2. Unscrew and remove the black shipping cap and

lubricate the riser tube located on the opening

of the tank. Make sure riser tube is ush with

the top of the tank.

1. Make sure the o-rings are lubricated before

installing. Lubricate both O-rings on the bottom

of the control valve (inner and outer).

5. Tighten the valve hand tight, then snug it

further by tapping it with the palm of the hand.

Rotate the Tank so the control head is facing the

front and the pipe connection is in the back.

DO NOT use tools to tighten the valve or

damage could occur.

3. Install the upper basket on the bottom of the

valve by lining up the tabs, pressing in, then

turning the basket counterclockwise to lock it

in place.

6. Attach the bypass valve onto the control head and

secure it with the metal plates, placing screws in

the hole closest to the control head. Make sure

the o-rings are lubricated before connecting.

(Silicone Grease recommended as lubricant.)

4. Place the upper basket over the distributor tube

and push the valve on the tank. Thread the valve

on the tank by turning it clockwise. Be sure not

to cross-thread the valve on the tank. The valve

should thread easily in the tank. If not, it may be

cross-threaded.

DO NOT LUBRICATE as you may over-tighten

the valve.