Manual

10
[e-mail] www.aquastarpoolproducts.com
877.768.2717 fax 877.276.POOL Outside the U.S.: +1.805.620.5060 fax [phone]
IMPORTANT
• Model:32PDxxx
• Singleormultipledrainuse
• AtIAPMO(anationallyrecognized
testing lab), the Propeller™ Drain 3/4”
sump and cover was tested with no
additional sump depth
• AllAquaStarchanneldrainsare
VGB 2008 compliant
• Plumbingtooneortwopumpsplus
skimmerequalizerareapproved–
DO NOT exceed maximum ow rate
of outlet cover for total system
• One-pipeconnectionmustbe
minimum2”pipesizeandcentered
along channel slot in sump
• Anyplumbingcongurationis
approved but do not exceed
maximum ow rate
• IMPORTANT:Tobeconsidered
unblockable, the Propeller™ drain
sump must be permanently and
securely axed to become an
integral part of the pool oor using
epoxy (ie. Aquabond UW 5000)
around the entire edge and all of the
enclosed plastic anchors or optional
brass anchors.
32" PINHOLE ANTIENTRAPMENT SUCTION OUTLET COVER AND PROPELLER
MANUFACTURED SUMP  32PDxxx INSTALLATION
The sump must be permanently and securely axed to the pool oor using epoxy (ie. Aquabond UW
5000) under the sump and around the entire edge and all of the enclosed plastic anchors or optional
brass anchors. Once this is completed, the sump becomes a permanent part of the pool structure,
creating an unblockable drain. The drain cover is then axed to the sump using the designated screws.
g. 1
SINGLE PIPE CONNECTION CAN BE
ANY SIZE AND CENTERED ALONG
CHANNEL SLOT.
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
GRAVEL
SHOTCRETE/GUNITE
USE 1/4" MASONRY DRILL BIT AND INCLUDED
PLASTIC ANCHORS OR 5/16" DRILL BIT AND
OPTIONAL BIK4 BRASS ANCHORS
TWO-PART EPOXY
UNBLOCKABLE SUMP
PINHOLE ANTI-ENTRAPMENT
SUCTION OUTLET COVER
EPOXY OR SILICONE
g. 2
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
STEP 1
GRAVEL
SHOTCRETE/GUNITE
UNBLOCKABLE SUMP
USE SCREWHOLES OF UNBLOCKABLE SUMP
TO POSITION DRILL
CENTER UNBLOCKABLE SUMP CHANNEL SLOT OVER PIPE
g. 3
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
STEP 2
GRAVEL
SHOTCRETE/GUNITE
INSTALL SCREW ANCHORS (PLASTIC OR BRASS)
APPLY TWO-PART EPOXY TO UNDERSIDE OF
UNBLOCKABLE SUMP