Manualshelf

Use and Care Manual

ManualsBrandsAquaRest Spas ManualsHot Tub Spas & Home SaunasDayDream 4500, 6-Person Lounger Hot Tub, Plug and Play w/ 45 Stainless Jets, Htr, Ozone, LED Waterfall, Ext LED Lighting
11121314151617181920
12
S
S
y
y
s
s
t
t
e
e
m
m
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
Initial Start-Up
When your Spa is first activated, it will perform a self-diagnostics test showing a series of numbers followed by Pr, then by
--along with the low speed pump for approximately 7 minutes total. Also, the internal clock that keeps track of the
filtration cycles every 12 hours will start at that point. The system is preset to heat up to 100° F (37° C) and it is also preset
to run on low speed for one hours (F1). If after the first 7 minutes water is not flowing from the jets you may need to
purge the pump. Please see page 21.
Temperature Adjustment
80° F-104° F (26°C-40° C)
The control’s display will constantly show the spa’s water temperature. To adjust the spa’s water temperature, press or
. The display will flash and show the current temperature setting. Each time either one of these buttons are pressed,
the temperature setting will change by 1°. After you have set the desired temperature, stop pressing the buttons, the
display will stop flashing after five seconds and the current spa temperature will show again.
Jets
Press the pad to power the pump. The pump will sequence with each press of the pad as follows: low flow – high
flow – off. If left running, the high flow pump will automatically turn off after 15 minutes (low flow in two hours). These
time out durations can be adjusted. See page 11 for details.
Adjustable LED Lighting
To turn the lighting on, press the button. Press again to turn it off. To adjust the color modes, press the button
immediately after turning it off. The lighting will come back on in a new color mode. Each time you repeat this
procedure, the lighting will cycle to a new color mode, as shown below. If left on, the light will automatically turn off after
four hours.
1. Color wheel. The light will slowly blend cycle
through the colors.
2. Aqua white.
3. Light blue.
4. Violet.
5. Dark blue.
6. Light green.
7. Dark green.
8. Red.
9. Step sequence through the colors.
10. Very slow color wheel.
11. Back to #1.
Spa Water Maintenance
This function enables you to program the amount of water filtration time.
Press or then to enter the programming mode.
Once in the programming mode press or to select the filtration time.
F1 In this mode the water will be filtered for 1 hour every 12 hours.
F2 In this mode the water will be filtered for 2 hours every 12 hours.
F3 In this mode the water will be filtered for 3 hours every 12 hours.
F4 In this mode the water will be filtered for 4 hours every 12 hours.
F5 In this mode the water will be filtered for 5 hours every 12 hours.
F6 In this mode the water will be filtered for 6 hours every 12 hours.
F7 In this mode the water will be filtered for 7 hours every 12 hours.
F8 In this mode the water will be filtered for 8 hours every 12 hours.
To exit press .