Owner Manual

15
E
E
q
q
u
u
i
i
p
p
m
m
e
e
n
n
t
t
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
Air Injection Venturi Adjustment
Air injection into the massage jet water flow may be controlled by turning the venturi dials located on either side of
the spa.
Surface Skim Filter
The spa’s automatic surface skim filter is designed to remove floating debris and contaminants such as body lotions by
drawing water through a specially formulated filter cartridge. It is critical that this element
be routinely cleaned.
Cleaning the Filter Cartridge
To clean the filter cartridge follow these steps:
1. Never operate the spa without the filter cartridge in place. It is difficult to remove the filter cartridge while
the water is flowing. Also, there is a risk that debris may be draw into the plumbing system, damage the
pump and void the warranty. Place system on Standby Mode (page 10) or disconnect power.
2. Remove the end nut by turning it counter clockwise (Fig 5).
3. Pull up filter cartridge (Fig 5).
4. At this point you can install a new filter cartridge and proceed to the next step. To clean the filter cartridge, take it to an
area where the run off drains to a sewer drain capable of safely assimilating the water which may contain both
unsanitary contaminants and chemical residue. Thoroughly rinse with the high pressure from a garden hose until the
filter cartridge is free of dirt and debris.
5. Return the clean cartridge to the filter well and turn the end nut clockwise until snug.
Fig 5