Owner Manual

22
Jet Tool
This wrench is used to tighten the small 2 inch (5cm)diameter jets when needed.
To tighten the jets, insert the hex portion of the wrench into the hexagon hole at the base of the jet and turn
clockwise. Do not over tighten.
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
G
G
u
u
i
i
d
d
e
e
SITUATION
PROBABLE CAUSE
ACTION
NO HEAT OR HEAT TOO LOW
Operating while spa cover is open.
Ensure that spa cover is properly closed.
Dirty filter
Replace or clean filter cartridge. Pg. 15
JETS WON’T COME ON
No power to spa control.
Check the GFCI, circuit breaker and/or disconnect switch.
NO CONTROL DISPLAY OR FUNCTIONS
No power to spa control.
Check the GFCI, circuit breaker and/or disconnect switch.
LOW WATER FLOW
Dirty filter.
Replace or clean filter cartridge. Pg. 15
Low water level.
Make sure water level in spa is correct.
NO AIR BUBBLES IN JET
Air control valve in the closed
position.
Open venturi dials. Pg. 16.
SPA IS LEAKING
Spa drain valve and cap partially open.
Ensure that drain valve and cap are fully closed. Pg. 8
SLOW WATER DRAIN
Drain valve not fully opened.
Ensure that valve is fully open. Pg. 8
Dirty filter.
Remove filter cartridge and clean. Pg15
Kinked garden hose
Ensure drain hose is not kinked and is in a downhill direction.
NO WATER FLOW FROM JETS
Air lock in pump
Purge the pump. Pg. 21