User Manual User Manual

ManualsBrandsAquametrix ManualsAccessories for waterSHARK TX / TXP Transmitters

MULTI-PARAMETER TRANSMITTER USER’S MANUAL

ORP - Utilities Menu - Meter Selection 5.4

ORP - Utilities Menu - Meter Selection 5.4 Page 34

DOWNDOWN

DOWN

DOWN DOWN

DOWN

If you do not wish to initialize to this

type of meter after all, then press

key to return back to the Meter

Selection menu

Then press

The controller will initialize itself for a

specific meter

If you do wish to initialize to this

type of meter, press the

key to highlight the Y character

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Press the key to Exit and

return to the Utilities menu

RUN MODE

Press the key to initialize the

controller as a Flow meter

Press the key to initialize the

controller as a Conductivity meter

The Meter Selection menu is used to select the meter type that the

controller is configured for, either pH, ORP, Conductivity or FLow.

Once selected, the controller will initialize itself for the selected meter's

functionality and move to run mode.

Press the key to initialize the

controller as an ORP meter

Press the key to initialize the

controller as a pH meter.

INITIALIZE? Y N

ORP

E XIT

MANUAL TEST MODE

500mV 25.0C

UTILITIES

CALIBRATION

METER SELECTION

C ONDUCTIVITY

FLOW

EXIT

F LOW

CONDUCTIVITY

O RP

CONDUCTIVITY

FLOW

ORP

P H

ORP

To reset the controller back to all

the factory default values, reselect

the current meter type