Full Product Manual

ManualsBrandsAquaLife ManualsHot TubsEminence Gray 80-Jet 6-7-Person 240-Volt Seating

Two-Pump Spas and

Two-Pump + Blower Spas

Jets 1

Touch the “Jets 1” button once to turn pump 1 on

or off, and to shift between low and high speeds. If

left running, the low speed of the pump will auto-

matically turn off after 2 hours, and the high speed

will automatically turn off after 15 minutes.

Jets 2

Touch the “Jets 2” button once to turn pump 2 on

or off and to shift between low and high speeds. If

left running, pump 2 will automatically turn off after

15 minutes.

Option (if equipped)

This button is used to turn on the blower/pump in 3

pump spas. This is 1-speed only and will turn off au-

tomatically after 15 minutes.

Lights

Press the Light button on the topside control panel

to turn the spa light on. If your spa has perimeter

LED lights, they will also light up at the same time as

the spa light. LEDs operate in four modes. The mode

is changed by turning the light off and then immedi-

ately back on

1. Fading: The lights will cycle through all the colors

in this order: White, Cyan, Magenta, Blue,

Yellow/Green, Green, Red

2. Color Locked: This cycle offers a hard color

change without fading.

3. Quick Color Change: Each time you press the

button, you advance to the next color.

4. Flashing white: The LED lights will flash white.

“WARM / COOL” Buttons

Control Pack Codes

See pages 32-34.

__________________________________________

Three-Pump Spas and

Two-Pump + Blower Spas

Jets 1

Press the “Jets 1” button once to turn pump 1 on or

off, and to shift between low and high speeds if

equipped. If left running, the pump will turn off after

a timeout period. The pump 1 low speed timeout on

some systems may be as long as 4 hours.

On non-circ systems, the low speed of pump 1 runs

when the blower or any other pump is on. It may

also activate for at least 1 minute every 30 minutes

to detect the spa temperature (polling) and then to

heat to the set temperature if needed, depending

upon mode. When the low speed turns on automat-

ically, it cannot be deactivated from the panel; how-

ever, the high speed may be started.

Jets 2 (optional on some systems)

Press the “Jets 2” button once to turn pump 2 on or

off. If left running, the pump will turn off after a

timeout period.

Jets 3 (optional on some systems)

Press the “Jets 3” button once to turn pump 3 on or