Owners manual

ManualsBrandsAquabot ManualsPool Cleaning & MaintenancePool Rover Jr Cleaner for Above Ground Pools

Operating Instructions For

AboveGround

Swimming Pool Cleaners

Residential Robotic

Owner’s Manual and Troubleshooting Guide

For Technical Support Please Call

1-800-845-4856 or You Can Visit Us on the Web

at www.AquaProducts.com/Service

Although the appearance (colors, shapes and features) of

your cleaner may vary from the pictures shown in this

manual, the operating and troubleshooting procedures

shown herein are the same.

Summary of content (8 pages)

PAGE 1
Operating Instructions For AboveGround Residential Robotic Swimming Pool Cleaners Owner’s Manual and Troubleshooting Guide Although the appearance (colors, shapes and features) of your cleaner may vary from the pictures shown in this manual, the operating and troubleshooting procedures shown herein are the same. For Technical Support Please Call 1-800-845-4856 or You Can Visit Us on the Web at www.AquaProducts.
PAGE 2
Dear Customer, Congratulations! You have purchased one of the best pool cleaners that technology has to offer! Your cleaner is a fully automatic, robotic pool cleaner equipped with the patented, powerful Jet Drive propulsion system.
PAGE 3
OPERATING FEATURES This manual has been created to represent the set-up and troubleshooting practices required for a variety of Aqua Products cleaners. Although the shape, color and some components featured herein may not be identical to those of your cleaner, their operating and service procedures are. As there are a variety of features and components for the various models produced, some pages may contain information showing each of these.
PAGE 4
Lock Pin in preset position Lock Pin (Top View) Curves counter clockwise in this direction Cleaning Pattern 1 Turnign Wheel Axle Goes straight in this direction In Preset position, the unit will clean in this counterclockwise pattern Fixed of moving straight Axle in one direction and arcing slightly in the reverse direction For Oval or Narrow Rectangular Pools Lock Pin in Forward position Note: Using a small nail (or a small screwdriver) punch front hole open (both sides).
PAGE 5
OPERATING INSTRUCTIONS For Technical Support Please Call 1-800-845-4856 Or You Can Visit Us On The Web At www.AquaProducts.com/Service IMPORTANT Caution: Do not switch the pool cleaner “on” if it is not fully submerged in water. This pool cleaners system has an internal timer, which will automatically shut off the cleaner after 2 hours of operation in your pool. However, the switch will remain in the “on” position.
PAGE 6
For Technical Support Please Call 1-800-845-4856 Or You Can Visit Us On The Web At www.AquaProducts.com/Service OPERATING INSTRUCTIONS Cleaning The size of your pool, and the amount of debris in it, will determine the length of time required to clean the pool. The time may vary from one to two hours. When your cleaner slows down considerably or constantly reverses direction before reaching the sides of the pool, it is sending a signal that it is time to clean the Filter Bag.
PAGE 7
TROUBLESHOOTING For Technical Support Please Call 1-800-845-4856 Or You Can Visit Us On The Web At www.AquaProducts.com/Service Does not vacuum as well as it should l Check to see if the Filter Bag is thoroughly clean. NOTE: Use the Fine Filter Bag to trap smaller debris such as algae, bacteria and silt. Use the Mesh Filter Bag (sold separately) to trap larger debris such as leaves, acorns, twigs and pine needles. It may be necessary to rinse the Filter Bag in a bucket of clean water.
PAGE 8
Warranty Statement A Message From Aqua Products Please read the following warranty statement carefully before taking any actions pertaining to repairs, servicing and especially returns. Aqua Products will not accept any cleaners from any sender without proper authorization codes and procedures being placed into effect. If you proceed without fully reading this statement, you may be placing your warranty in danger of becoming voided. Thank You, Aqua Products, Inc.