Specifications

ManualsBrandsAqua Systems ManualsHome building and DecorAQLP Series

Automatic System Operation

The Aqua Logic controls most of your pool equipment automatically in order to minimize the time spent

working on your pool. Most of the pool equipment can be programmed to operate on a timeclock basis.

In addition, the desired pool and spa temperatures and pool and spa chlorinator settings can be pro-

grammed. This section will guide you on how to program the automatic operation for each function.

The programming of automatic functions can be performed at either the main display/keypad located at the

pool equipment pad or the in-home remote display/keypad.

Using the programming buttons

There are 5 buttons on each keypad that are used for programming (refer to diagram).

There are 4 steps to programming any function:

Press the “MENU” button to get to the desired menu. Multiple pushes of the

button will rotate through all 5 menus and return to the starting point.

Press either key to scroll through the various items in the selected menu. Multiple

pushes of the button will rotate through all menu items and return to the starting

point. Only menu items that are applicable to your pool will appear. (Example: if

you don’t have a spa, then no spa related menu items will appear).

3. Once a menu item has been selected above, the current setting/selection will ap-

pear (flashing) on the display. Use the “+” and/or “-” keys to change this selec-

tion. Sometimes “+” and “-“ will adjust a value up or down (example: heater

temperature setting or timeclock on/off time). In this case, pushing the “+” or “-”

will change the value by one increment and holding the “+” or “-” button in for

more than one second will make the values auto scroll. In other cases, the “+” and

“-“ may toggle between 2 options (example: turning superchlorination ON or

OFF).

After you have adjusted the item to the desired value, simply move on to the next

menu item to “lock in” your new setting. The Aqua Logic memory will maintain

the setting, even if power is removed for an extended period.

Settings

Display

“+” and “-” Buttons

Menu Button

Adust

Select Desired Menu

Select Items from

a Menu

“<” and “>” Buttons

Troubleshooting and Diagnostic Information

The Aqua Logic provides 2 different tools to aid in troubleshooting any problems that may occur in your

pool and/or spa system. The Service mode will allow you to disable automatic operation and manually

control most of the equipment (the heater and general purpose Valve3 output are the exceptions). The

Diagnostic Menu will provide some detailed information regarding system operation.

While both of the features are primarily intended for the use of the professional service technician, their

function is fully explained below. If you believe your system is not operating properly or have questions

regarding the operation, call the Goldline Technical Service Department from Monday through Friday,

8AM to 8PM EST at 888-921-7665.

Service Mode

The main unit keypad has a SERVICE button that is used primarily during servicing of the pool equipment.

If you want to completely disable the automatic operation and operate the system manually, you can put

the system into Service or Service-Timed mode by pressing the “Service” button. Pressing the “SER-

VICE” button once will switch the system into service mode which means that all automatic functions are

disabled, the optional remote display/keypads are disabled (except for manual turn off for emergencies).

The outputs can be manually controlled by pressing the buttons on the local display/keypad. The red

“SERVICE” LED will be illuminated and the Aqua Logic will remain in this mode of operation until manu-

ally taken out of service mode.

Pressing the “SERVICE” button again will cause the Aqua Logic to switch to service-timed mode which is

very similar to service mode, except that the Aqua Logic will automatically return to normal operation after

3 hours. During service timed operation, the “SERVICE” LED will flash and the time remaining will be

displayed on the remote display/keypad(s).

Pressing the “SERVICE” button again, will return the Aqua Logic to normal (automatic) operation.