Installation guide

AQUA SPAS Gold TV Spa Installation Guide
Aqua Spas 13
5. WINTER MODE
Freezing water temperatures can cause damage to equipment in the spa. The spa includes a winter mode to prevent this. When water temperature
drop below 5°C the heater will turn itself on to raise the temperature of the water to 8°C.
To turn on the winter mode, use the +/- buttons until the control panel displays ‘ON’. Press OK to continue.
6. CORRECTING TEMPERATURE ERRORS
From time to time the actual temperature in the spa may differ from the displayed temperature. For example, If the temperature displays 33°C
when it is actually only 30°C, then it is possible to calibrate the thermometers that monitor temperatures in the spa.
Use the +/- buttons to select the difference between the actual and displayed temperatures. Press OK to confirm and continue.
7. RESTORING FACTORY SETTINGS
To restore the spa to factory settings, use the +/- buttons until the panel displays ‘ON’. Press OK to confirm.
8. EXITING THE MENU
To exit the menu, simply press the OK button.
2. Heating Your Spa
To set the temperature of the spa, press the button. Use and to adjust the 'Set Temperature'.
When the 'Set Temperature' is higher than the 'Actual Temperature', the spa will turn on the Circulation Pump. The heater will then turn itself on
after 30 seconds.
When the 'Set Temperature' is lower than the 'Actual Temperature', the spa will turn off the heater, the circulation pump and ozonator will
automatically turn on. The spa will automatically enter 'Filter Mode'.