Installation guide

AQUA SPAS Gold TV Spa Installation Guide
Aqua Spas 10
FILLING UP, CHECKING, AND STARTING YOUR SPA
Although your spa has been water tested for at least 1 hour in the factory, some loosening of fittings can occur during shipping.
Before any decking, tiling or carpeting is completed around the installation, fill and operate your spa to test for leaks (this ensures easy access
and inexpensive correction). Check all union connections and plumbing for minor leaks. In the event of a leak, ensure all union connections are
tight and o-rings/gaskets are in place.
Ideally, the spa should be filled using a standard garden hose, turning the tap on slowly to prevent damage to the surface by a jerking hose
connection
Fill to the recommended level, approximately 10cm - 12cm below the edge of the spa
PRESET THE TEMPERATURE
It is recommended that you could preset the temperature through the computer controlled-panel. Once the temperature of hot water is lower than
the temperature preset, the ceramic heater will automatically heat the water inside, until the preset temperature is obtained.
When you operate the water pump, the ceramic heater will start to operate automatically.
WARNINGS
THE THERMOSTAT CANNOT BE OPERATED WHEN THE WATER PUMP HAS STOPPED
For more detailed operation guide, please refer to the heater instructions enclosed.
Turn the main power “on” at your electrical panel
Turn the breaker for computer controlled-panel “on” at your electrical panel
If the spa pump is located below water level, the water should start circulating immediately. If the motor works but you do not notice
water circulation within the first 15 seconds, the pump may require priming due to trapped air (referred to as an ‘air lock’).
PLEASE DO NOT OPERATE THE WATER PUMP WHEN THE WATER LEVEL IS LOWER THAN THE POSITION OF THE LARGE JETS.
THE HEATER WILL NOT OPERATE IF THE WATER LEVELS DO NOT COVER AT LEAST 3/4 OF THE FILTER WINDOW.
FILTERS
Filters
Water should be cleansed with your chosen sanitizer before using the filter.
Trail Operation of the Filter
Check whether the valve and connector in the pipe are completely sealed. The handle on top of the filter must be tightened.
Filtering
Once the filter system has been turned on, water will flow continuously through the filter. Over time, particles and dust will gather in the filter.
For this reason, the filter should be cleaned every two weeks and replaced at least once every year.