Operating instructions

Index Content Value
[0] Manufacturer 128 (for Danfoss)
[1] Device type 1
[2] Version xxyy
[3] Firmware date year yyyy
[4] Firmware date
month
ddmm
[5] No. of axes variable
[6] Vendor specific: PB
Version
xxyy
[7] Vendor specific: Da-
tabase Version
xxyy
[8] Vendor specific:
AOC Version
xxyy
[9] Vendor specific:
MOC Version
xxyy
The device identification parameter. The data type is "Array[n]
of Unsigned16“. The assignment of the first subindexes is de-
fined and shown in the table above.
NB!
This parameter is not visible via LCP.
9-65 Profile Number
Range: Function:
Read only
0
*
[0 - 0] This parameter contains the profile identification. Byte 1 con-
tains the profile number and byte 2 the version number of the
profile.
NB!
This parameter is not visible via LCP.
9-70 Edit Set-up
Option: Function:
[0]
[1]
[2]
[3]
[4]
[9]
*
Factory Set-up
Set-up 1
Set-up 2
Set-up 3
Set-up 4
*Active set-up
Choose the set-up in which programming (change of data) will
be performing during operation.
It is possible to programme the 4 set-ups independently of the
set-up selected as active.
Parameter access from each master will be directed to the set-
up which has been selected by the individual master (cyclic,
acylic MCL1, first acyclic MCL2, second acyclic MCL2, third acy-
clic MCL2).
See section
Parameter Access in General .
9-71 Save Data Values
Option: Function:
Parameter values changed via Profibus are not automatically
stored in non-volatile memory. Use this parameter to activate a
function that stores parameter values in the EEPROM non-vol-
VLT
®
Profibus 6. Parameters
MG.33.C4.02 - VLT
®
is a registered Danfoss trademark 75
6