Operating instructions

8-1
SECTION 8: SPECIFICATION & OPERATING DATA
ITEM MCA0751
MCA0751M
APIR075S
APIR075M
MCA1001
MCA1001M
APIR100S
APIR100M
MCA1501
MCA1501M
MCA2001
MCA2001M
APIR200S
APIR200M
MCA3001
MCA3001M
Nominal Media Volume, cu. ft. (cu. mtr.) (1)
0.75 (0.02) 1.0 (0.03) 1.5 (0.04) 2.0 (0.06) 3.0 (0.08)
Gravel Underbed, lbs. (kg)
9 (4.1) 13 (5.9) 13 (5.9) 18 (8.2) 26 (11.8)
Nominal Capacity, (ppm-gal)
22,500 30,000 45,000 60,000 90,000
Flow Rates, gpm (lpm) (2)
Continuous (no duration limit)
Service (10 min. or less)
2.0 (7.6)
4.0 (15.1)
3.0 (11.4)
6.0 (22.7)
3.0 (11.4)
7.0 (26.5)
4.0 (15.1)
9.0 (34.1)
5.0 (18.9)
12.0 (45.4)
Pressure Loss @ Flow Rates, psi (kPa)
Continuous (no duration limit)
Service (10 min. or less)
Backwash Flow Rate, gpm (lpm) (3)
1 (6.9)
4 (27.6)
3.5 (13.2)
2 (13.8)
5 (34.5)
5 (18.9)
2 (13.8)
7 (48.3)
5 (18.9)
2 (13.8)
8 (55.2)
7.0 (26.5)
2 (13.8)
10 (68.9)
10.0 (37.9)
Inlet/Outlet Pipe Size, inches (cm) (4)
1.0 (2.5)
Mineral Tank Diameter x Height, inches (cm)
8x44
(21x112)
10x44
(26x112)
10x54
(26x137)
12x54
(31x137)
14x65
(36x165)
Minimum Space Required, inches (cm)
Width
Depth (w/Bypass)
Height (Including Valve)
12 (31)
16 (41)
53 (135)
12 (31)
16 (41)
53 (135)
12 (31)
16 (41)
63 (160)
12 (31)
16 (41)
63 (160)
13 (33)
16 (41)
74 (188)
Approximate Shipping Weight, lbs. (kg)
123 (55.8) 157 (71.2) 210 (95.2) 264 (119.7) 385 (174.6)
Maximum operating temperature 100º F (38º C)
Electrical requirements 110V/60Hz
Operating pressure 20-100 psi.
Specifi cations are subject to change without notice.
NOTES:
1) Replenishment of pH adjusting component of media may be required periodically, the frequency of which is dependent on raw
water pH, manganese concentration and water consumption rate. Consult dealer for more information..
2) For satisfactory performance, indicated durations should not be exceeded. Flow rates specifi ed are adequate for normal resi-
dential applications. Do not use Service or Peak fl ow rates when sizing commercial applications or if treated water is to supply
a geothermal heat pump, swimming pool, etc. (contact dealer before selecting equipment). Service fl ow rates have been tested
against NSF Standard 42 and have a rated pressure drop of less than 10 psi.
3) For system to operate properly, pumping rate of well pump MUST be suffi cient to backwash unit at rate specifi ed.
4) Service pipe size is 3/4 (1.9) on models not shown above: MCA0750, MCA1000, MCA1500, MCA2000, MCA0750M, MCA1000M,
MCA1500M, MCA2000M