Troubleshooting guide

14
CLEANER STORAGE
When not in use it is important that your cleaner, its Floating Cable and Power Supply are properly stored in a clean and dry
area, away from direct sunlight, protected from below freezing temperatures and exposure to chemicals and their fumes (i.e.
chlorine). This will help prevent any unnecessary wear or damage to your cleaner or its components. Prior to storing your
cleaner, thoroughly clean your Filter Bag and dry off your cleaner. Ensure that its Floating Cable is untangled, not twisted
nor in a figure eight, but rather coiled either around your cleaner’s body or in large circular loops and positioned under your
cleaner. Be sure to rest your cleaner on its side so that its Brushes do not get flat spots.
IN-SEASON STORAGE
It is not recommended to leave your cleaner in the pool when not in use. Doing so, will reduce the life of your Filter Bag and
pool cleaner. After removing the cleaner from the pool you should clean the Filter Bag and rinse down your entire cleaner to
help extend its life and reduce fading. Then, rest the cleaner in a dry, shaded area along with its Power Supply and properly
coiled Floating Cable.
OFF-SEASON STORAGE
In areas where the pool will be closed you should remove your cleaner from the pool and thoroughly clean the Filter Bag.
Make sure that there is no water residue in the cleaner. Completely untangle and then properly coil the Floating Cable. Your
cleaner and Power Supply should be stored in a dry, protected area away from potentially freezing temperatures.
TROUBLESHOOTING
Reverses before reaching the opposite end of the pool
• Turn the Time Control Dial (located on the Power Supply) clockwise a few degrees or adjust the digital timer using the “up” button
to increase the time between reversals. Repeat if necessary.
• Check to see if the Filter Bag is thoroughly clean and installed properly.
Waits too long at the side of the pool before reversing
Turn the Time Control Dial on the Power Supply counter-clockwise a few degrees or adjust your Digital Timer using the “down”
button to decrease the time in between reversals. Repeat if necessary.
Floating cable is twisting
• Your new pool cleaner was designed to clean most pools without issue, but some pool shapes may cause the Floating Cable to coil,
or tangle. This cleaner operates in a systematic cleaning pattern that varies in nature. This may cause the Floating Cable to twist. For
this reason we have added the EZ-Swivel™feature to most cleaners. This patented feature will allow you to untwist your Cable easily.
Disconnect the Power Supply Cord from the Power Supply, place your cleaner on the ground outside of the pool perpendicular to
you. At the end of the Power Cable, located near the connection plug to the Power Supply, is the EZ-Swivel™ plastic handle. Grab the
handle firmly. Walk away from the cleaner while pulling the handle. This will cause the Cable to rotate within the plastic handle and
force the Cable to untwist itself. For best results remember to pull the handle until the Cable is completely untwisted.
TIP! Cable straightening and untangling is made fast and simple with Aqua Products’ optional E-Z Swivel Cable Detangler.
The “E-Z Swivel” is available to purchase through your Aqua Products Authorized Dealer or online at AquaProducts.com.