Operator`s manual

8
SETTING THE DIGITAL TIMER
PLEASE READ THE USER MANUAL FIRST
Your Cleaner is equipped with a 90 second DIGITAL TIMER located on the Power Supply.
To operate it please do the following:
Switch the Power Supply ON pressing the Power Switch to the ON position.. The display will FLASH two horizontal 1.
bars.
Observe the time required for the machine to move across the pool, at its widest point from one side to another. For 2.
details regarding this operation please see the “Operating Instructions” chapter from your User Manual.
To override the built-in 2 hour automatic shut-off timer, you may operate your cleaner in “Continuous Run (C-Run)” 3.
mode. This will enable your cleaner to operate continuously until either an external time source automatically or
someone physically turns the cleaner off. Only models that are equipped with the External Auto Timer feature will
be able to automatically restart by an external timer. Models without this feature will remain off. To restart start
models without the External Auto Timer feature, simply press the Power Switch to the OFF position and then back to
the ON position, then press the “Reset” button on the digital panel of the Power Supply. Your cleaner will commence
operation as per the already set 0 to 90 seconds forwards / reverse time cycle.
Press the C-RUN button. The machine will start to run and the GREEN LIGHT indicator above the C-RUN button lights 4.
up to confirm the operation.
Now your unit will work in Continuous Operation Mode and it will stop only when the operator will turn the machine 5.
OFF from the main switch.
As an option, you ca set the machine to turn off automatically after 2 hours. To do so, press the OPT button. The 6.
GREEN LIGHT indicator above the OPT button is selected the machine will stop after 2 hours.
PLEASE NOTE: In addition to the user selected operation time, the timer has a default shutdown for 5 seconds every 5 minutes.
CHANGING THE TIME SETTING:
The User can change the time (0-90 seconds) at any time, even as the pool cleaner is operating in the pool.
Pleasekeep in mind that whenever the timer is in operation, you will find the LEDs labelled “I” and “0” will be lit
alternately. The RED LED “I” indicates that the timer is in operation for the selected (0-90 seconds) time. The GREEN
LED “0” indicated that the timer is turned off (for a default 1 second ).
Up & Down
arrow buttons
Red “ON” LED
Digital timer
display
Green LED
Continuous Run
(CRUN) button
RESET button
CONTINUOUS OPERATION
Press the C-RUN button, both the green LED above the
C-RUN button and the Red “ON” LED will illuminate.
The Cleaner will now clean your pool until you stop it by
switching the Power Supply Switch to the “OFF” position.
TIMED OPER ATION
You can control the length of the cleaning cycle by using
the control pad on the Power Supply. Press the “UP” arrow
button once for each hour of operation you desire (up to
7 hours). When you have selected the proper number of
hours, press the RESET button you have set the cleaning
time you may add or subtract hours by simply pressing the
“UP” or “DOWN” arrow button. This may be done while
the cleaner is in operation. The Power Supply will shut
down and restart every eight minutes. This feature well
help keep the cleaner from becoming stuck in the pool.
Set the operating mode for your cleaner after the cleaner has been placed in the pool, the Floating Cable from
the cleaner has been plugged in to the Power Supply and the Power Supply has been plugged into a GFCI
protected 115v electrical outlet.
WARNING: In “Continuous” mode, the Safety Reset Button is inactive and cannot protect your cleaner from
accidental “out of water” starts.
The Power Supply should be placed in a sheltered area, at least twelve (12) feet away from the pool. While
the Power Supply is weather-resistant, it should be placed in an elevated area where it will not sit in puddles
of water.