Operator`s manual

10
CLEANER MAINTENANCE - CLEANING AND/OR CHANGING THE FILTER BAG
NOTE: Make sure that the Power Supply is turned OFF and that the cleaner’s Floating Cable is unplugged from the Power
Supply before removing your cleaner from the pool.
1. Place the cleaner on its back on a non-abrasive surface and release the two Lock Tabs on the underside of the cleaner.
2. Using your thumbs, push the Lock Tabs away from the center of the cleaner to unlock the Bottom Lid Assembly.
3. Remove the Bottom Lid Assembly out from the body of the cleaner.
4. Remove the Filter Bag from the bag support wire frames.
Turn the Filter Bag inside out (the Fine Filter Bag has a soft felt-like surface on the inside) and discard the large debris,
and wash off visible dirt using one of the following methods: (a) High pressure with a garden hose (B)Faucet. With any
mothod gently agitate the Bag in your hands to help remove fine particles while wringing, cleaning and squeezing the Bag
gently until rinse water is clear. Use of a washing machine (cold water, gentle cycle only) is recommended when visible
dirt will not rinse off by other methods. DO NOT USE DETERGENT or BLEACH! DO NOT MACHINE DRY!
Turn the Filter Bag “right side out” (felt-like surface on the inside) remount the Bag on the Wire Frames making sure that
the Label on the Bag is centered on either of the long sides of the Bottom Lid Assembly directly beneath one of the Wire
Frames. At the top, pull, excess Bag toward the middle of each Wire Frame so that the Bag corners are snug against the
corners of the Wire Frame W-Shaped Bottom Lid Assemblies: Tuck the excess Bag into the U-shaped section of the Wire
Frames.
Re-install the Bottom Lid Assembly. Make sure that neither debris nor the Filter Bag itself interferes with complete closure
of the Bottom Lid Assembly. A locking sound from each Lock Tab will be heard when locked properly.
IN-SEASON STORAGE
It is not recommended to leave your cleaner in the pool when not in use. Doing so, will reduce the life of your Filter Bag
and pool cleaner. After removing the cleaner from the pool you should clean the Filter Bag and rinse down your entire
cleaner to help extend its life and reduce fading. Then, rest the cleaner on its side in a dry, shaded area along with its
Power Supply and properly coiled Floating Cable. (see figure 1)
OFF-SEASON STORAGE
In areas where the pool is closed you should remove your cleaner from the pool and thoroughly clean the Filter Bag.
Make sure that there is no water in the cleaner. Completely untangle and then properly coil the Floating Cable. Your
cleaner and Power Supply should be stored in a dry, protected area away from freezing temperatures. Make sure your
cleaner is stored away from any open containers of chlorine and/or other harmful chemicals. (see figure 2)
Figure 1
Figure 2