Troubleshooting guide

PRODUCT SETTINGS and TROUBLESHOOTING
Your cleaner is equipped with two adjustable suction ports on the underside
of the unit. Both can be lowered to maximize the suction strength for picking
up smaller debris. The suction ports are set to the lowest position by default.
To adjust the ports, turn the cleaner over and use a Phillips head screw driver
to loosen the screw on the ports. Pull out the ports to the desired length and
tighten the screw again. Do not over tighten the screw.
ADJUSTING THE SUCTION PORTS
Underside view of the cleaner showing
location of adjustable suction ports
Select models have a passive agitator brush. This brush is not a moving part
or powered by your cleaner. It is meant to pass over your pool floor and
agitate dirt and debris in order to get vacuumed up into the cleaner.
NOTE: Please do not attempt to remove this brush.
PASSIVE AGITATOR BRUSH (select models)