820406 POOL ROVER SERIES 2 ROBOTIC POOL CLEANER PRODUCT SETTINGS AND TROUBLESHOOTING GUIDE PLEASE READ CAREFULLY BEFORE USING YOUR POOL CLEANER Aqua Products, Inc 282 Grove Avenue Cedar Grove, NJ 07009 United States
product settings and troubleshooting WARNINGS WARNING: Do not turn the Power Supply on, unless the pool cleaner is in the water. WARNING: Do not operate your machine while people swim in the pool. WARNING: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times! See diagram below. WARNING: To prevent possible electric shock hazard this unit must be connected to an RCD (Residual Current Device) with a related residual operating current not exceeding 30mA.
product settings and troubleshooting PRODUCT SETTINGS There are 2 possible configurations that the axle can be locked into. With the cleaner flipped over and movable axle furthest away, the axle must always be set in front of the pin. See the diagram below. AXLE AND TURNING PINS Your cleaner moves about your pool by way of 1 adjustable pin located on each end of the axle on the bottom side of the cleaner. There are various positions that the pins can be set.
product settings and troubleshooting Top View of Inside the cleaner PRODUCT SETTINGS RE-INSTALLING FILTER BAGS AFTER CLEANING After you have cleaned the filter bags of the collected debris, you’ll need to re-install them back into the cleaner. Make sure the elastic opening covers all the way over the opening and that the Velco® end is secure. The filter bag should stretch all the way out from end to end. See the diagram for proper placement. NOTE: Your filter bag is machine washable.
product settings and troubleshooting ADJUSTING THE SUCTION PORTS Your cleaner is equipped with two adjustable suction ports on the underside of the unit. Both can be lowered to maximize the suction strength for picking up smaller debris. The suction ports are set to the lowest position by default. To adjust the ports, turn the cleaner over and use a Phillips head screw driver to loosen the screw on the ports. Pull out the ports to the desired length and tighten the screw again.
product settings and troubleshooting WARNINGS WARNING: Do not turn the Power Supply on, unless the pool cleaner is in the water. WARNING: Do not operate your machine while people swim in the pool. ON / OFF WARNING: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times! See diagram below. WARNING: To prevent possible electric shock hazard this unit must be connected to an RCD (Residual Current Device) with a related residual operating current not exceeding 30mA.
Aqua Products, Inc 282 Grove Avenue Cedar Grove, NJ 07009 United States
