user manual

c. Screw the baseplate in the desired position (screws supplied by installer).
d. Plug the power supply’s output connector into the mating connector on the
back of the AQL2-Wx-RF-PS-x.
e. Reattach the wireless remote display/keypad to the baseplate.
f. Plug the power supply into a 120VAC outlet.
Installation - AQL2-Tx-RF-PS-x and AQL2-Tx-RF-P-4
Table Top models
1. Base Station required: For operation of the AQL2-Tx-RF-PS-x and AQL2-Tx-
RF-P-4 models, the Aqua Logic control unit must have an AQL2-BASE-RF Base
Station installed.
2. Select Location: Because both models are battery operated and designed to be
portable, there are no power supply or mounting concerns like the Wall Mount
units. The Table Top units are intended to be used in the normal living space,
with these considerations:
Protected from the weather: The wireless remote display/keypad should be
used indoors or in a weather protected area (rain should never hit the wire-
less remote display/keypad). Understand that areas that protect the unit
from rain, may still allow condensing humidity (dew, mist, fog, etc.) which
can damage the AQL2-Tx-RF-PS-x and AQL2-Tx-RF-P-4 over time. Because
the unit is portable and may be used in different areas around the pool and
home, it's important to understand that it is NOT water resistant and can be
easily damaged if used in the wrong manner.
Within range of base station: The wireless remote display/keypad must be
used within 250 ft. (assuming the signal will have to travel through walls) or
500 ft. (line of sight) from the AQL2-BASE-RF Base Station which is typically
mounted on the Aqua Logic main control unit at the pool equipment pad.
The base station can also be mounted up to 500 ft. away from the main
2
9
Push Screwdriver
blade through slot
and pull up
cover
Bezel
(use is optional)
back of baseplate
Fig. 1
Fig. 2