Manual

7
If debris is still lodged inside the cleaner, you must remove the apper. To do this you
must take out the four red plugs in the foot pad. These are found on the bottom of the
cleaner. They can be removed using a at head screwdriver. Underneath there will be four
screws. Unscrew them and remove the foot pad from the main body. Once removed
there is a plate. Remove the single screw from this plate and slide it out of the main body.
This will expose the apper and it can be pulled out.
Remove any debris that may be inhibiting the apper. Once dislodged insert the apper
back into the body. Slide the plate back into position and re-screw it into place. Then
re-install the foot pad. Make sure that all are securely in place.