Manual

4
S
S
T
T
E
E
P
P
4
4
Your cleaner hose comes in 3’ sections which
must be connected together. The hoses are
connected by inserting the male cu of one
section of hose into the female cu of another.
Twist the sections of hose together until you
establish a snug t (See gure 5). You will need
to assemble enough sections of hose to reach
from where the cleaner connects to your
skimmer to the opposite end of the pool, plus one
section. For example, if you have a 21’ round
pool, you will need to connect 8 sections of hose
for a total of 24’ of hose.
ASSEMBLE THE HOSE
NOTE
One of the hose sections has 2 female ends.
This section should be tted last and will attach
to the pool’s vacuum connection. Save extra
sections of hose for replacements.
S
S
T
T
E
E
P
P
5
5
This is done by simply attaching the valve to
the last section of hose. The advantage of using
the valve is that it balances the ow of water
between the skimmer and the cleaner . The
valve is str ongly r ecommended for maximum
performance, however is only necessary in
instances wher e there is excessive pump ow .
Excessive suction will make the cleaner move
too fast and could damage the vacuum’s
components and/or decr ease the cleaner’s ability
to navigate the pool. In these instances the
automatic regulator valve must be used. This
will help r estrict ow of water and make the
cleaner operate more eciently.
INSTALL AUTOMATIC
REGULATOR VALVE
NOTE
Automatic Regulator Valve must be installed
so the bypass port is always facing down and is
below the water level.
S
S
T
T
E
E
P
P
6
6
To install the eyeball diverter remove the
original eyeball fr om the r eturn by unscr ewing the
lock ring. Replace the original eyeball with the
cleaner eyeball diverter. Replace the lock ring
and tighten. The best way to position the eyeball
diverter is so the ow is directed downward.
This will help eliminate the r eturn ow from
interfering with the cleaner.
INSTALL EYEBALL DIVERTER
Figure 5
Eyeball Diverter
Lock (Retaining) Ring
Eyeball Diverter
Eyeball Fitting
Figure 7
Suction Bypass Port
Male End Of Hose
Flow Control Valve
Figure 6