User guide

12
Chapter 4. Preparation for use
Connecting power source
This unit was designed to operate with AC adaptor.
Connecting this system to any other power source may
cause damage to the system. Take the following steps to
use the adaptor. Unwind the power cord of the adaptor to
its full length. Connect the DC plug to the DC in socket on
the rear of the unit, and then pug the adaptor to the AC
outlet (100-240V~50/60Hz). Make sure the AC adaptor is
fully inserted into the mains power outlet. The set is now
connected and ready to use.
To switch the unit off completely, withdraw the power
adaptor from the wall outlet.
1. Do not plug or unplug the power cable in wet hands
2. Please disconnect the mains plug from the AC outlet
if the appliance is not going to be used for a long period
of time.
Installing and replacing the battery of the remote
control
The remote control requires one”CR2025 type” 3-Volt
lithium battery (included). To extend the life of the original
battery we have inserted a small clear plastic spacer tab
between the lithium battery and the battery terminal. You
must remove this battery spacer tab before you use the
remote control. To remote the table, pull it in the direction
of the arrow in the illustration,