Product Info

perating Basics 2-17

PC Cards

PC cards, sized like credit cards, are inserted into the PC card slots to

provide specific functions such as memory, fax/modem, networking, and

PCMCIA Type III 1.8-inch hard disk drive.

PC cards that conform to the PCMCIA 2.1/3.0 standard can be used

with your Qbe. Two advanced interfaces are also supported: CardBus

and ZV (Zoomed Video) port. CardBus and ZV port standards are

developed to provide high-speed data transmission required by

applications such as full-motion video, video capture, and networking.

Inserting and Removing a PC Card

1. Locate the PC card slots at the rear left side of the PCT. Remove

the “dummy” card(s) by depressing either one of the two buttons.

The upper slot is Slot 0 and the lower Slot 1.

2. To insert a PC card, with the label facing up, slide it into the

appropriate slot until the eject button pops out.

(graphic)

Figure 2-8. Installing a PC Card

To remove a PC card, press the corresponding eject button. The

card will pop out partially. Slide out the card and store it properly.

3. See the documentation supplied with your PC card for further

instructions.