User Manual

4
How to clean grinder
1. Daily cleaning: Clean the residual powder with the included brush is ok.
2. Moderate cleaning: Scrub the machine and smashing body with a wringed
wet towel. Remember to use it again before all moisture is dry.
3. Deep cleaning: Wash the smashing body with a small amount of water.
Attention! Before washing, please tilt the smashing body to the maximum angle
(open side down). Do not allow any water entered engine! After washing, use a
dry clean dishcloth dry it soon. Only all moisture is dry then you can use the
grinder again.
4. Please notice that all cleaning work must be done after the power is turned
off.
How to replace the blade
Use a screwdriver to jam the buckle under
the blade, and then loosen the nut on the
blade counterclockwise with a wrench.
How to change the carbon brush
Please find the carbon brush port on both side of the
grinder.
Please rotate the nut counterclockwise with a slotted
screwdriver till the little carbon brush loose enough
to take out.
Put your new carbon brush into the port, and
tighten the nut clockwise.
Overload Protector Button ( Reset Button )
If air overload protection pops out due to abnormal
reasons during crushing, check and remove hidden
dangers first. Then plug in and press the protector,
wait for extra 5 minutes for grinder automatically
resetting.