User Manual
Table Of Contents
- APWONE Electric Grain Mills Grinder
- Instructions
- General Information
- APWONE Grinder Structure
- Technical Parameter
- Product Usages
- 1.Daily cleaning: Clean the residual powder with the
- 2.Moderate cleaning: Scrub the machine and smashing
- 3.Deep cleaning: Wash the smashing body with a small
- 4.Please notice that all cleaning work must be done
- How to change the carbon brush
- Please find the carbon brush port on both side of
- Please rotate the nut counterclockwise with a slo
- Attention and Warnings
3
Technical Parameter
Type: APWONE 350G/500G/750G/1000G/2000G Electric Grain Mills Grinder
Material: 304 Stainless Steel
Voltage: 110V-60HZ
Motor Speed: 25000(r/min)
Working Time: 5 minutes
Interval Time: 10 minutes
Crushed Level: Superfine mill
Degree of Grinding: 50-300 Mesh
Capacity: 350G-0.77 lbs; 500G-1.1 lbs; 750G-1.65 lbs;
1000G-2.2 lbs; 2000G-4.4 lbs
Power: 350G-1900w; 500G-2300w; 750G-2600w;
1000G-2800w; 2000G-3500w
Product Usages
1. Open the top cover (Clockwise to close, counterclockwise to open).
2. Put the dry material into smashing body (according to different product
sizes and models).
3. Close the cover, tighten two buckles.
4. Adjust the red adjustment screw to tighten smashing body on base.
5. Plug in power, LCD display lighten.
6. Please adjust the working time 10-50 seconds / 1-5 minutes.
7. Please press the on/off button to start grinding.
8. Grinder will stop automatically when time is up.
9. Or you can also press the on/off button to stop it.
10. After grinding finished, please unplug the power first for safety.
11. Open the cover after machine stops working completely. Pour out the
powder. Clean up the powder stuck in the smashing body with the brush in
package.