Operating instructions

ADJUSTING FOR VARIABLE CHINA SIZES
INSTRUCTIONS:
6-1/2” TO 9-3/4” China:
10-3/4” China:
Align outermost hole in tube head with the storage hole as shown in Figure 1 below. Insert rods into
desired setting and securely screw down rod stops.
Rotate tube head to position shown in Figure 2. Insert rods through unit so they pass inside the black
head weldment below and outside the offset ring weldment to which the springs are attached.
Securely screw down rod stops. This will allow for greater stability and improved rod alignment at
the 10-3/4” china size.
1
2
3
Tube
Head
Storage Holes
Figure #1 Figure #2
ITEM NUMBER DESCRIPTION PART NUMBER
1 Adj.Tube Head L-9A and HL-9A 201159-00
1 Adj. Tube Head L-12A and HL-12A 201160-00
2 Guide Rod 209315-00
3 Guide Rod Nut 209313-00
All other components are the same as the L-9 or HL-9 and the L-12 or HL-12
!!
EQUIPMENT PREPARATION
Clean the unit before using. Wipe body and the inside of the unit with a hot, wet cloth to remove any shipping
dust or protective oil.
!
!