Operating instructions

GENERAL INSTALLATION:

1. Always clean equipment thoroughly before first use. (See general cleaning instructions)

2. Check ratings label for your model designation and electrical ratings.

3. For best results, use stainless steel countertops.

4. Attach legs to unit.

GENERAL OPERATION INSTRUCTIONS:

1. Trained personnel should operate all food service equipment.

2. Do not allow your customers to come into contact with any surface labeled "CAUTION

HOT".

3. Where applicable, never pour cold water into dry heated units.

4. Where applicable, do not cook, warm or hold food directly in liner/well pans. Always use

steam table pans/inserts, etc.

5. NEVER hold food below 140° F.

GENERAL CLEANING INSTRUCTIONS:

1. Never clean any electrical unit by immersing it in water. Turn the unit off and allow it to cool

before surface cleaning.

2. Always clean equipment thoroughly before first use. Clean unit daily. Except where noted on

charts: use warm, soapy water. Mild cleansers and plastic scouring pads may be used to

remove baked-on food and water scale on metal unit. NOTE: do not clean roller tubes with

abrasive cleaners or scouring pads. Follow instructions on page 6.

3. Unplug electrical unit before cleaning or servicing. All service should be performed by an

APW Wyott authorized service agency.

GENERAL TROUBLESHOOTING:

Always ask and check:

1. Is the unit connected to a live power source?

2. Check the circuit breaker.

3. Is power switch on and pilot light glowing?

4. Check the rating label. Are you operating unit on the proper voltage?

If the above checks out and you still have problems, call an APW Wyott authorized service agency.

INSTALLATION

Place the HOTROD directly on a countertop or on a matching APW Wyott Bun Warmer or Bun Cabinet

(available separately). Place the unit close to an AC outlet, of the correct voltage, to avoid undue strain on

the power cord.

CAUTION: To avoid equipment damage, make certain that the nameplate voltage is the same as the outlet

voltage.

If the plug is to be removed and replaced with a plug more suitable for your area, the color code for the

power cable is:

Neutral (N) = White or Blue Live (l) = Black or Brown Safety Earth (E) = Green or Yellow/Green

After a suitable location has been chosen, wipe the rollers and the drip pan with a damp cloth. The unit is

ready for use.