Operating instructions

3
LOCATION OF DATA PLATE:
The data plate for the Coldwell is located on the compressor housing above the power switch.
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All containers should be examined for damage before and during unloading. The freight carrier has
assumed responsibility for its safe transit and delivery. If equipment is received damaged, either apparent
or concealed, a claim must be made with the delivering carrier.
A) Apparent damage or loss must be noted on the freight bill at the time of delivery. It must then be signed
by the carrier representative (Driver). If this is not done, the carrier may refuse the claim. The carrier can
supply the necessary forms.
B) Concealed damage or loss if not apparent until after equipment is uncrated, a request for inspection
must be made to the carrier within 15 days. The carrier should arrange an inspection. Be certain to hold all
contents and packaging material.
Installation and start-up should be performed by a qualified installer who thoroughly read, understands and
follows these instructions.
!
!
CAUTION: Maintenance & repair should be handled by a factory authorized agent. Before doing
any maintenance or repair, contact APW Wyott.
WARNING: Install per the spacing requirements listed in the installation section of this manual. We
strongly recommend having a competent professional install the equipment. A licensed electrician
should make the electrical connections and connect power to the unit. Local codes should always
be used when connecting these units to electrical power. In the absence of local codes, use the
latest version of the National Electrical Code.
!
!
!
!
WARNING: SHOCK HAZARD - Do not open any panels that require the use of tools.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read the Installation, Operating and Maintenance Instructions
thoroughly before installing or servicing this equipment.
!!
!
!
WARNING: Never clean any electrical unit by immersing it in water. Turn off before cleaning
surface.
!
!
WARNING: SHOCK HAZARD - De-energize all power to equipment before cleaning the
equipment.
!
!
WARNING: Appliance must be connected by an earthing cable to all other units in the complete
installation and thence to an independent earth connection.
GENERAL TROUBLESHOOTING
If the unit fails to operate check the following:
1. Make sure the unit connected to a live power source.
2. Check the circuit breaker to be sure it has not been tripped.
3. Check if the power switch is on and the indicator light is glowing.
4. Check the data plate and make sure the unit is operating on the proper voltage?
If the above checks out and you still have problems, call an APW WYOTT authorized service agency.
NOTICE: Service work should be performed only by a qualified technician who is experienced in and
knowledgeable with the operation of commercial gas, electric, steam cooking equipment. Contact the
Authorized Service Agency for reliable service, dependable advise or other assistance and for genuine
factory parts.
Warranty will be void and the manufacturer is relieved of all liability if:
(A) Service work is performed by other than an APW WYOTT Authorized Service Agency; or
(B) Other than Genuine APW WYOTT replacement parts are installed.