User's Manual

-6-
Installations
1. Setting Up Your Light
* Hang the cable from the head cable
relief hook to manage and reduce
tension on the cable.
** Disconnect the XLR head cable by pushing down on the locking tabs on the female XLR connectors, then
remove the cable.
2. Connect the light to the control box
Baby Pin (5/8in. / 16mm)
Mount the lamp head onto a light stand, then fix it in place by tightening the T-Handle
on the mounting column. Then loosen/tighten the handbrake locking mechanism on
the yoke to adjust the tilt of the fixture.
Junior Pin
Remove the T-Handle from the Junior Pin and screw it into the T-Handle Storage Hole
on the yoke. Place the light into the Junior Pin Receiver on the stand, and tighten down
the T-Handle on the receiver.
Connect the light to the control box with a 5-Pin Male-to-Female XLR cable (3m or 0.6m)
as shown below.
DMX IN Port DMX OUT Port 5-Pin Female XLR Control Box Input
PUSH
PUSH
XLR Locking Tab
XLR Locking SlotXLR Locking Slot
XLR Locking Tab
PUSH